This page provides directions to help you not only finish the Netgear EAX50 setup but also improve the firmware, reset the factory fails, and change the password. In summary, this page functions as the Netgear EAX50 extender user manual. Start going.
How to Set Up Netgear EAX50 Range Extender?
The below instructions for setting up the range extender via mywifiext.net setup
In the same room where you have plugged your WiFi router
connect your EAX50 to an open electrical outlet.
After rebooting your router, turn on the Netgear extender.
On your laptop or PC with WiFi capability
open the WiFi settings and look for the Netgear_EXT default SSID of the extender.
For access to the internet via WiFi of the EAX50 extender
the password provided on the product label.
Use a web browser to visit mywifiext net right now.0
You will then be sent to the New Extender Setup page.
How to Improve Performance and Security of EAX50?
In order to improve the performance and security of your Netgear EAX50 WiFi range extender
,you have to update the firmware and change the admin password.
it can’t be done until you complete Netgear extender login via 192.168.1.250 IP address or visit mywifiext.
NOTE : If you need any help regarding your wavelink wifi range extender so get in touch with the technician or visit the official web site that is mywifiext.net setup
Netgear eax50 setup wps method
This follow the instrucition:
Plug In: Connect your Netgear EAX50 to a power outlet.
Press Router WPS: Press the WPS button on your router.
Press Extender WPS: Within 2 minutes, press the WPS button on your Netgear EAX50.
Wait for Connection: Wait for the WPS LED on the EAX50 to stop blinking and turn solid, indicating a successful connection.
Updating the Firmware Netgear eax50 setup
Connect your computer to your router with an Ethernet cable.
Visit NETGEAR Support.
Enter your router's Model Number or Product Name.
Click Downloads.
Select a firmware version and click Download.
Unzip the file if needed.
Enter routerlogin.net into a web browser.
Netgear eax50 setup login not working
Make sure your computer or device is connected to the Netgear EAX50 network.
Open a web browser on your device.
work, check if you’ve changed them previously.
If you still can’t log in, you might need to reset the extender to factory settings.
press and hold the reset button on the extender for about 10 seconds until the LED blinks.
After resetting, try logging in again using the default credentials.
Netgear RAX50 Router Reset instructions
How to Reset the Netgear RAX50 Router To Factory Default
Turn on the Netgear RAX50 router
Look for the reset button.
Few routers have a tiny hole and few others have a reset button.
Press the Factory reset button with a straightened paper clip pin or something that gets through the tiny hole
For about 15 seconds! (till you see all the lights flashing)
The Netgear RAX50 router will reboot automatically.
The unit has been reset and is ready to use.
You can start from this guide to set it up.
